Add Adjacent Floor Points

After doing some Floor editing recently in Revit, I realized that my Match Adjacent Points workflow does not have the ability to add adjacent points. So I decided to test out a new method that could add points from an adjacent Floor that were along a shared edge. Somewhat surprisingly, this method can also be used to match adjacent points without replacing them.

And this workflow can be used twice on two Floors to match points from each.

Continue reading

Match Floor Points Update

I have a slight update and correction to last week’s post, Match Adjacent Floor Points. A reader pointed out that the definition also reset all non-adjacent points to zero. So, I went back and modified the node and the definition so Continue reading

Toposurface to NurbsSurface

In Revit, Toposurfaces are Mesh elements. By definition, a mesh contains points, edges, and faces. Topos are always more manageable to edit when they have fewer points and edges, but all of those edges can also make them appear unrealistic.

There are a variety of methods you can use to smooth out those edges, but one of the quickest ways to do this is to convert the Topo into a Nurbs Surfaces (in Dynamo, of course).

Continue reading